DROWsports Universal GY6 Ruckus Wire Harness Component Plate Handlebars & Grips Exhaust Valve 21mm

Exhaust Valve 21mm

This kit completely removes the rear CBR250R fender and relocates the factory turn signals

Every performance piston requires proper lubrication which is commonly forgotten about once it comes down to the actual piston

Resistor Covers come equipped with 5 k ohm ceramic resistors to help in the reduction of "Electro Magnetic Interference" and "Radio Frequency Interference" which can interfere with electronic ignition components causing misfires and poor engine performance

The setup of the main and low jet along with inlet sizing and airflow optimization increases performance with lower fuel consumption

DROWsports Universal GY6 Ruckus Wire Harness Component Plate Handlebars & Grips Exhaust Valve 21mmThe DROWsports Universal GY6 Ruckus Component Plate has been crafted to neatly arrange parts such as the CDI, Flasher Relay, and Rectifier. The necessity for drilling to position the components will depend on the specific Swap Harness being used.