3 Pcs Set Draw Bar Collet Chuck 1/2", 3/8", 1/4", MT2 Taper, with Inner Thread 3/8 "x16TPI for Woodturning Wood Lathe. NCK series Chucks & Jaws From simple bevels to side

From simple bevels to side ground variations

and workpieces up to 5/8 inch in diameter

This range of quality

This enables you to grind the fingernail grind on gouges and allows you also to vary the profile to give you a long or short grind

Fitted with jackscrews for safety reverse running

3 Pcs Set Draw Bar Collet Chuck 1/2", 3/8", 1/4", MT2 Taper, with Inner Thread 3/8 "x16TPI for Woodturning Wood Lathe. NCK series Chucks & Jaws From simple bevels to sideDrawbar Collet Chuck are designed for use with Drawbar Collet Chuck system MT2. Inexpensive quality chucking system for turning small projects like spinning tops, birdhouse finials and similar items where accuracy and tool accessibility are a priority. Many professional pen turners prefer using a drawbar collet chuck for holding pen mandrels as it eliminates the risk of off center pen barrels and project tubes so you get the very best results